Arlon DPF White Ultra Tack Arlon’s DPF is a 90 micron, satin white, high-tensile, PVC film with aggressive, permanent adhesive. Designed to stick to . The ultimate premium film for hard to stick surfaces. A durable film combined with a high tack adhesive system allows you to use one film for all your difficult. “We use Arlon DPF every day because of its durability and price point. We wrap a lot of brick walls and needed something that would hold up in heavy.
|Published (Last):||11 February 2013|
|PDF File Size:||11.67 Mb|
|ePub File Size:||8.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
Concrete, Masonry, and Tile The surface should be entirely dust free: The trade-off for high tack and adhesion is to expect higher visible shrinkage than normal. Application in cold temperature environments.
Standard warranty applies to vertical applications only. When printing this product be vigilant about drying the finished decal completely before laminating, top coating or installing. We do not recommend wrapping gasoline tanks or similar plastics exposed to like fumes. These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame.
Graphics Removal Remove the film in a continuous smooth motion at a shallow angle for the fastest separation. Due to the porosity of certain types of plastics i. This is contingent upon no rain or harsh outdoor weather conditions.
DPF ™ Ultra Tack | North America | Arlon Graphics
Dust due to ablation cannot develop under the vinyl. Rough surfaces may not carry the standard warranties. Click here to see the WrapItRight video: Remove the film in a continuous smooth motion at a shallow angle for the fastest separation. Printed durability is dependent on the ink system used. For many polyolefinic surfaces, once the oily skin of the plastic dpg modified bond will improve dramatically.
Where it is practical, two people on the removal make the job go far faster than using just one.
Arlon DPF Mil 5yr | FELLERS
The surface must be sealed with a complete coat of paint or concrete sealer and allowed to dry. For this arpon, an edge seal is recommended for applications that have very rough surfaces.
Addition of heat during cpf will make the process much cleaner and faster. To assure highest adhesion the graphics will benefit from a final installation pass using a soft roller and heat source in combination. The film installs best on flat surfaces when processed and applied according to Arlon recommendations.
Sealing porous surfaces creates three benefits: Plastic These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame.
Where only one person is working there will be constant starting and stopping in addition to the problems of the heat being very inconsistent.
With one person working the heating unit in front of the second person who is peeling film, the job proceeds at a uniform and consistent pace. Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or ice to seep between the film and wall and collect on the upper edges of fpf applied graphic.
If the surface is not sealed there must be no loose paint, grit or chalk present. Special Considerations Because of the porous nature of all masonry and its general 800, Arlon does expect water, snow or ice arloon seep between the film and wall and collect on the upper edges of the applied graphic.
Non-vertical applications are not warranted for this product. PP, PEplastics exposed to gasoline from tanks will migrate through plastic and interfere with vinyl adhesion to the plastic.
DPF 8000™ Ultra Tack
The surface should be entirely dust free: As a result, it is best practice to not leave the printer 800 when printing to avoid headstrikes due to adhesive build up on the film edges over time. Removal steps are much easier as the adhesive will remove more cleanly and if any adhesive remains, the surface will be cleaned of residue more easily.
The film should be heated to a point ar,on softening. Moisture cannot wick to the adhesive surface from within the matrix of the wall.